Before & After

What a restoration job actually looks like: the damage we start with, and what a properly dried, cleaned and restored property looks like when we leave. Each project below describes the scope, not a single address — every home is different, but the process is the same.

Water Damage Restoration project in Bowie, MD — burst washing-machine hose, first floor

Bowie, MD · Water Damage Restoration

Burst washing-machine hose, first floor

Before: Water tracked under vinyl flooring and into the kitchen subfloor overnight. Carpet in the hall was saturated and the baseboards were wicking moisture.

After: Extraction within hours, baseboards removed and dried, subfloor dried and confirmed with moisture readings, flooring re-laid and the hallway re-carpeted.

Mold Remediation project in Crofton, MD — basement mold after a sump-pump failure

Crofton, MD · Mold Remediation

Basement mold after a sump-pump failure

Before: Approximately 30 square feet of dark spotting along the lower drywall and carpet tack after the sump pump failed during a storm.

After: Area contained, affected drywall and carpet removed, HEPA filtration throughout, antimicrobial treatment, framing dried and clearance testing before rebuild.

Water & Sewage Cleanup project in Laurel, MD — sewage backup into a basement floor drain

Laurel, MD · Water & Sewage Cleanup

Sewage backup into a basement floor drain

Before: Heavy rain overwhelmed the lateral line; contaminated water covered the basement floor and soaked the bottom inch of drywall.

After: Category 3 cleanup — contaminated materials removed and disposed of properly, floors disinfected, drying equipment run to measured targets, sanitization documented.

Fire & Smoke Damage Restoration project in Silver Spring, MD — smoke damage in a kitchen fire

Silver Spring, MD · Fire & Smoke Damage Restoration

Smoke damage in a kitchen fire

Before: Fire contained to the kitchen, but soot coated the adjoining living space and smoke had settled into cabinets and upholstery throughout the floor.

After: Water extracted from firefighting, soot removed by material, cabinets and contents cleaned, thermal fogging and ozone treatment for odor, drywall and trim replaced.

Mold Inspection & Remediation project in Rockville, MD — attic moisture after a roof leak

Rockville, MD · Mold Inspection & Remediation

Attic moisture after a roof leak

Before: A slow roof leak fed moisture into attic sheathing for months before the musty smell was noticed from the bedrooms below.

After: Thermal imaging located the wet areas, air samples taken before and after, affected insulation removed, framing dried and the leak source corrected with the roofer.

Carpet & Upholstery Cleaning project in College Park, MD — carpet restoration after a supply-line leak

College Park, MD · Carpet & Upholstery Cleaning

Carpet restoration after a supply-line leak

Before: An upstairs supply line failed over a bedroom carpet, leaving water rings in the padding and high humidity that set off an odor.

After: Pad replaced, carpet dried in place with air movers, hot-water extraction with antimicrobial treatment, and a full room clean once the humidity was back to normal.

We photograph every job we do

Documentation protects your claim and tells you exactly how the work was done. Your own before-and-after record is included at no extra cost.